TWP 120 Pecan is the newest color in the 100 series line and was introduced as an alternative to the 101 Cedartone. This color is what we call a slightly brown/cedar color. Basically, a little bit of brown was added to the 101 Cedartone to “tone down” the traditional orange cedar color.
TWP 100 Series comes in 9 different color choices, 8 of which are semi-transparent. TWP penetrates into the wood grain while “enhancing” the natural color tones of your wood. TWP 120 is an EPA registered wood and deck stain and preservative. Containing unique ingredients which protect wood from damage, TWP 120 stain color has been a leader and respected product for over 25 years.
Final TWP 120 Pecan color will vary based on:
- Type of Wood
- Age of Wood
- Prepping of Wood
- Application method
TWP 120 Pecan Photo Gallery
If you have used the TWP 120 Pecan, we would love to see your photos!
Please add them in the comment area below.
Can I mix Pecan with Dark Oak for a darker tone? Thanks!
Yes!
How long will the opened can of stain last? For example can I store it and use it 3-4 years later to restain?
https://twpstainhelp.com/shelf-life-of-twp/
Is the 1500 pecan darker or lighter than the 100 pecan?
No noticeable difference.
Cost of 15 gals twp 101 delivered to 98221
All of our 5-gallon pails ship free. You can order them here: https://www.twpstain.com/twp100-5gallon-detail
Can TWP be used to reseal a log cabin?
Yes, as long as you prep correctly first.
I am paint my walls I like to know what would look the strip is pecan stain
Sorry, but we do not understand your question.
Just finished my deck (for the second time) using TWP 100 Pecan. Prepped with Restore-a-deck products. Once again, very satisfied.
Hi, do you have any installed pictures of 120 Pecan on Ipe?
We do not.
ok thanks–is your stain recommended for Ipe?
You can use it on IPE but IPE wood, does require annual cleaning and recoating.
I have a new boat dock that I am staining (preserving) and want to use the 120 Pecan. it is 1,187 sq. ft.so I figure at two applications I will use a bit less than 12 gallons. Is this a bit much? Or, should I plan on better than 200 sq ft coverage?
10-12 gallons for two coats is correct.
The following is one coat of pecan on prepped 1 year old pressure treated lumber. We love the stain so far!
How many weeks ,after the application, does it take the stain to fully cure?
It fully cures in a few days in most scenarios.
I applied the Pecan 120 a couple weeks ago to my cedar deck! I understand the stain normally lasts only a couple years before requiring a new coat! However, my South facing deck receives full sun ? all day long! No shade at all! It’s brutal and extremely hard on the stained surface. So, I’m experimenting with an idea to extend the life of my stained deck surface. I bought a white waterproof tarp that I cover my deck with to prevent the ultraviolet rays from beating the surface! My deck is well ventilated , thus gently moving the tarp and enabling good air circulation! What do you think? I figure the 4-5 hot, full sun months are doing the most damage…and covering the deck could give me another year without a recoat?
Pictures to support prior email.
Not sure if it will work or not but should not harm it.
I’ve found UV causes the most degradation of color and finish, way more than moisture exposure. I keep our stained cedar/treated pine patio furniture in the garage in the winter and the finish lasts way longer than year round outside exposure. I think your tarp will help.
I stained my new deck floor boards the cedar TWP 100 last season. This season, the color is very faint, and I have some white residue around some of the knots. Not sure if I can attribute both of these issues to the wood still being new. I did wait 8 months before staining btw. Anyway, was thinking about transitioning to the 120Pecan color. Can I reapply the stain directly on top of what is there now after deck cleaning? Want to also make sure the 100 series is the best option for me. I live in Michigan, so the wood does get quite a drastic hit from weather, and gets afternoon soon directly.
The white is sap and cannot be prevented. If you prep with the Gemini Restore Kit then you can use the TWP 120 Pecan
Brand new pressure treated deck with cedar rails that had aged for 10-months prior to using the gemini restore-a-deck kit. Once the wood was dry, deck and rails were stained with TWP 100 Series in Pecan 120.
Looks great!
Why does the 1500 series claim the stain can be “cleaned and recoated easily” , while the 100 series does not mention that? If I assume I’ll have to reapply the TWP every 2 yrs….which series is easier to reapply?
They both can be cleaned and recoated as needed. No difference.
I assume the TWP 120 Pecan is slightly darker/less orange than the TWP 101 Cedartone?
Yes, it is a browner version of the Cedartone.
I just stained my 12 x 24 deck with TWP 100 series Pecan. My deck is 13 years old. We used 2 gallons as the wood was sucking the stain up. We ran out with 5 boards to go. When we got to the bottom of the can all the pigments were on the bottom. We did shake the can before starting to stain but we didn’t know that the stain had to be stirred to get that mixture off the bottom of the can. Therefore, not much of those particles got mixed in the stain. Has the degradation of the stain been compromised or is that mix on the bottom of the can just the colorant and will not hurt the preformance of the actual stain: ie sealant, UV protection and penetration?
You will be fine.
I have 5 year old cedar deck that stripped & brightened with rad kit about 5 weeks ago, then the rains came. After 2 weeks brightened again but started raining once a week since & now it has been 2 more weeks & wood very slightly greying. Waiting for next weather window of at least a week without rain.So should I clean & brighten or just brighten? will be staining with twp 100 pecon. We are in Seattle wa.
Lightly clean and brighten.
Does lightly clean mean spray on cleaner let set 5 min or so then lightly pressure wash off? then apply brightener
Correct.
Why is my pecan stain (twp 120) so dark? I sanded, washed, and brightened the 20 yr old deck. Two coats, wet on wet, w/ 24 hour dry time. Is it the wood type, a reaction with the brightener, or something else?
Wood porosity and type of wood. Color always varies based on this. The older the wood the more porous it is and that means the stain will be darker as the wood will take more stain.
If I wanted to go with a different color I would have to strip and brighten, correct? How well does the stripper take off fresh stain? Should I use an additive?
It will take it off, use the additives.
This is good to know. My deck is about 25 years old and is redwood. I’m thinking it will also darken like this, so I may opt for a lighter color.
Samples: https://www.twpstain.com/stain-samples
Even after 4 years, I’m very pleased with the results of the pecan. The color lightens as the stain is absorbed and weathered.
Can i put a coat of 100 series pecan over the 1500 series i applied last year?
No, you would have to stay with the 1500 or remove if you want to go with the 100 Series with this kit: https://www.twpstain.com/restore-a-deck-stripper-brightener-kit-detail
Waited 1 year after purchasing the trailer to stain it. The deck is “treated yellow pine decking”. Looks good. I haven’t put the sideboards back on yet since staining them but when I do I’ll take more pics..
Looks great! Thanks for sharing.
My cedar deck was stained one year after it was built as we were told to wait 1 yr.
the color stain is Twp pecan, the deck came our orange. Awful color, also the knots are brown. Any way to restrain to bring it to a brown color?
Final color on your wood will always vary based on wood type, age, application, etc. This is why we offer samples and pictures. The Dark Oak is a brown color. You could use this after prepping with this: https://www.twpstain.com/restore-a-deck-stripper-brightener-kit-detail
I have few questions, please:
1. Is humidity during the application process a factor in determining the end result?
2. I hate orange. I understand honeytone is the most natural color and pecan is like cedartone with a little brown mixed in. Which is the LEAST orange? I have reviewed the photo gallery, but I don’t want to be confused by lighting differences.
3. What are the differences between the 1500 and the 100, other than the VOCs? What makes the 100 line better for new decks?
Thank you!
1. No
2. Best to test samples on your wood to see how it will look as colors will vary: https://www.twpstain.com/stain-samples
3. Performance is the same for the Series. The TWP 100 soaks in better for new wood.
Is there any difference in the color between the 100 series and the 1500 series pecan?
Yes. The colors between the series are not exact but close.
At what temp is to hot to put it on?
Around 95.