TWP 100 Series Deck Stain - The Best Deck Stain

TWP 100 StainNeed Help or Advice when using TWP 100 Stain?

Total Wood Preservative (TWP) Wood Deck Stain protects and prolongs all exterior woods, decks, and fences. TWP Wood Deck Stains and Sealers is a distinctive mixture of chemicals blended together to form a professional strength formula that preserves exterior wood surfaces in numerous ways. 

TWP 100 Series Stain will perform at its maximum potential when the wood is properly prepped and when the stain is properly applied. Unfortunately not all wood is in the same condition prior to applying the stain.

 

Do you have any questions about using the TWP 100 Wood and Deck Stain?

Please answer these few questions to achieve the best possible results with your TWP 100 Wood and Decking Stain.

  1. info buttonAge of wood?
  2. Type of wood?
  3. Condition of the wood?
  4. Has it been stained previously and if so with what brand of stain?
  5. Small description of the area to be treated.

Ask Questions in Comment Area Below

Ask a Question or Post a Picture...
You are guest ( Sign Up ? )
or post as a guest
Loading comment... The comment will be refreshed after 00:00.
  • We will reply to your comment shortly
    TWP Stains · 06/30/2013
    Lou, we do not receive an order from you.
  • We will reply to your comment shortly
    Louis J. Ferony Jr. · 06/29/2013
    I tried to order 5 gallons of TWP 100 Cedartone. Entered all info to include creditcard , it did not appear to take and I got no email conformation. I don't want to double order, suggestions?

    Thank you,
    Lou Ferony
  • We will reply to your comment shortly
    TWP Stains · 06/29/2013
    Leon, if it is shiny then that means the stain did not penetrate completely. This is usually from over applying, improper prep, or combination of both. I would wipe the deck down with some lacquer thinner and some rags to remove the excess on top. Them let it dry for a few more days. Make sure to wet your rags with water when done to avoid accidental spontaneous combustion.
  • We will reply to your comment shortly
    leon belli · 06/28/2013
    washed redwood deck & power washed, applied honey tone 1500, its still looks shiny, used your product 2 years ago and did not have this problem. its been 5 days, still looks like i used olive oil, is there a way to wash this down a bit, without starting all over?
  • We will reply to your comment shortly
    TWP Stains · 06/28/2013
    You should not apply the 100 if it is going to rain 5 hours later. Too much of a risk. It may be fine but we cannot say for sure. Best to give it closer to 12 hours.
  • We will reply to your comment shortly
    Christina · 06/28/2013
    I have a cedar deck that I have sanded, cleaned and brightened all last week. I live in Mn and today is the first open window where we haven't had some rain in two days. They are saying 30% chance of rain. How fast does TWP 100 dry? Can I still apply it this morning and if it rains 5 hours from now will the stain be okay? I have been waiting over a month to have enough open windows to get this done.
  • We will reply to your comment shortly
    TWP Stains · 06/28/2013
    Dan D, you need to strip both the fence and the deck with the Restore A Deck Stain Stripper. Once all of the old coatings are removed you should apply the RAD brightener. Once fully prepped then you can use the TWP 100 Series.
  • We will reply to your comment shortly
    TWP Stains · 06/28/2013
    Dan E, I would use the TWP 1500 for this to achieve maximum UV protection.
  • We will reply to your comment shortly
    Dan d · 06/27/2013
    Fence:
    -6 years old
    -cedar
    -gray toned color
    -initially stained with Thompsons Water sealer
    -what refinishing process would you recommend?

    Deck:
    -5 years old
    -cedar
    -stained with Sikkens DEK, horizontal surfaces are in varying stages of peeling/bare wood. Vertical surfaces are good in some locations and starting to peel in others
    -what refinishing process would you recommend.
    -location is Omaha, Ne
  • We will reply to your comment shortly
    DanE · 06/27/2013
    I will be re-staining a cedar fence that is 3 years old. I originally applied Behr Transparent, but most of is has peeled off. I have removed the remaining stain and weathering. I would like to get recommendation on the best TWP product to use. I live in Kansas
  • We will reply to your comment shortly
    TWP Stains · 06/27/2013
    Gary, Prep with the Gemini Restore Kit then stain with the TWP 1500.
  • We will reply to your comment shortly
    Gary Maleck · 06/26/2013
    My deck is PT SYP and is 3 years old. Never been stained, wood is gray and gets half sun & half shade. Some mold near house. Wood is in pretty good shape. Which of your products do you recommend?

    Thanks,
    Gary Maleck
  • We will reply to your comment shortly
    TWP Stains · 06/26/2013
    Jane, I would use the TWP 100 Series for this unless you are in a low VOC state. You would then need the 1500 Series.
  • We will reply to your comment shortly
    Jane F. Griffin · 06/26/2013
    age of wood - 1 year
    cedar
    good, has been cleaned within last two weeks
    not stained previously
    deck with cedar bench seating surrounding
  • We will reply to your comment shortly
    TWP Stains · 06/26/2013
    No it cannot. It is not compliant for Canada's VOC laws
  • We will reply to your comment shortly
    Carl Phillips · 06/26/2013
    Can TWP be used in Ontario?
  • We will reply to your comment shortly
    TWP Stains · 06/26/2013
    Billy63, no TWP 100 is not compliant for IL. Just the TWP 1500.
  • We will reply to your comment shortly
    Billyp63 · 06/26/2013
    Can I use the twp 100 in Illinois?
  • We will reply to your comment shortly
  • We will reply to your comment shortly
    Chad S · 06/25/2013
    Thanks. Since it is hard to get a good feel just from the little color sample on the website, is pecan basically a light brown when applied to cedar? I'm just trying to find the best way to cover the orange without it becoming too dark. Now that I know I can mix the colors, I guess I could just keep adding dark oak into the cedar until I get the result I like better.