TWP 100 Series Deck Stain - The Best Deck Stain

TWP 100 StainNeed Help or Advice when using TWP 100 Stain?

Total Wood Preservative (TWP) Wood Deck Stain protects and prolongs all exterior woods, decks, and fences. TWP Wood Deck Stains and Sealers is a distinctive mixture of chemicals blended together to form a professional strength formula that preserves exterior wood surfaces in numerous ways. 

TWP 100 Series Stain will perform at its maximum potential when the wood is properly prepped and when the stain is properly applied. Unfortunately not all wood is in the same condition prior to applying the stain.

 

Do you have any questions about using the TWP 100 Wood and Deck Stain?

Please answer these few questions to achieve the best possible results with your TWP 100 Wood and Decking Stain.

  1. info buttonAge of wood?
  2. Type of wood?
  3. Condition of the wood?
  4. Has it been stained previously and if so with what brand of stain?
  5. Small description of the area to be treated.

Ask Questions in Comment Area Below

Ask a Question or Post a Picture...
You are guest ( Sign Up ? )
or post as a guest
Loading comment... The comment will be refreshed after 00:00.
  • We will reply to your comment shortly
    TWP Stains · 09/23/2013
    Andrew, yes you would wan the 100 Series. Make sure that all of the old stain ans removed first. Using a stripper and wood brightener will help.
  • We will reply to your comment shortly
    Ana Correa · 09/23/2013
    5 yr old PTP deck and porch both covered in Charlotte NC. Both have never been stained and are in good condition. Both also were professionally cleaned with a cleaner solution a couple months ago. We were planning on ordering and doing this in the next week or two so we would like your recommendations on which product.
  • We will reply to your comment shortly
    Andrew Goldman · 09/22/2013
    Florida pressure treated dock on salt water.... Approx 15 yrs old, but 40% has been replaced over the past 5 yrs.. Have used super deck products for the past ten years but had to buy there water based product two yrs ago and very unhappy... I pressure wash the deck before applying stain.. Total of 800 sq ft..... Usually takes 7 gallons of stain... Assume TWP 100 is the best product for my application.... Thanks ........
  • We will reply to your comment shortly
    TWP Stains · 09/22/2013
    Mike, I would wait until Spring.
  • We will reply to your comment shortly
    Mike Roehl · 09/22/2013
    Stained my deck and Pergola with cedar tone 100 this spring .the results after a complet restore process on the deck were great. Shoul I clean and brighten this fall and apply a second coat before winter?
  • We will reply to your comment shortly
    TWP Stains · 09/21/2013
    Dave Martin, you are ready to go now since it has been about 4 months. Prep first with the Gemini Restore Kit and apply only one coat of the stain the first time.
  • We will reply to your comment shortly
    Dave Martin · 09/20/2013
    How long should I wait before staining my new deck? Treated wood was used and it has been about 4 months.
  • We will reply to your comment shortly
    TWP Stains · 09/18/2013
    HL Manning, either would be fine but the 1500 has a little more solids so it will give slightly better UV protection.
  • We will reply to your comment shortly
    H L Manning · 09/18/2013
    Western Cedar fencing 160 ft. installed in spring. 80 ft. cedar fence 4 yrs. old just power washed today, previously finished with CWF and was peeling. What product do you recommend? 100 or 1500?
    Thanks
  • We will reply to your comment shortly
    TWP Stains · 09/17/2013
    1. Yes it will be fine through the winter
    2. I would let the shingles weather as well
  • We will reply to your comment shortly
    David · 09/17/2013
    I've been slowly building a treehouse constructed entirely of pressure-treated pine (deck, framing, siding, railing) and western red cedar roof shingles. It has all aged at a different rate since it has taken so long to construct, but the oldest wood has been exposed to the weather for about 4 months now while the newest wood is still wet from the store. None of it has been stained yet. I can see the decking (which has been up the longest) has faded quite a bit and will probably be gray in a couple months, while the newest wood is quite "yellow". I'd like to wait until Spring and let the wood age a little more before I stain it.

    My questions are these:
    1. Is the pressure-treatment enough to protect the wood for the next 5-6 months through the winter in TN?
    2. Is it better to let the cedar shingles age and turn gray before staining them? I'm debating whether to stain them before I install them (easier to get to).
  • We will reply to your comment shortly
    TWP Stains · 09/17/2013
    Lynn, you could try a very light re coat. If that does not work then you need to strip off the stain and start over.
  • We will reply to your comment shortly
    lynn rew · 09/16/2013
    I have put stain on deck and before it could dry it rained and I now have white milkey spots on deck they are water spots how do I now correct problem
  • We will reply to your comment shortly
    TWP Stains · 09/15/2013
    Ken B, I would use the 150 for this after prepping with the Restore A Deck Stain Stripper and Brightener.
  • We will reply to your comment shortly
    Ken B · 09/15/2013
    Live in North Dakota, have cedar deck and fence. Deck 5yrs old and fence 3 years old. Used Penofin Blue Label 2 yrs ago. Wondering if I should use the 100 or the 1500. Any advice?
  • We will reply to your comment shortly
  • We will reply to your comment shortly
    nak · 09/14/2013
    new 600sf ipe horizontal deck, installed 1 month ago in
    Texas. small area (50sf) that receives most sun starting to show greying. do i need to wait any longer b4 staining? I'm okay with the color as it is. Do you recommend restore a deck on a new application?
  • We will reply to your comment shortly
    TWP Stains · 09/13/2013
    The Restore A Deck Stripper.
  • We will reply to your comment shortly
    Doyle White · 09/13/2013
    What product is best to use to remove & start over for the TWP 1500 Stain?

    Doyle
  • We will reply to your comment shortly
    TWP Stains · 09/13/2013
    That is just mineral deposits from the rain water. Just wipe off with a wet rag.