Injectable Safe-Strip provides never before technology by allowing a deck/wood stripper to be injected by a pressure washer at up to 1,000 square feet per concentrated gallon! Use 100% Biodegradable Safe-Strip to remove unwanted sealers or semi-transparent stains. Safe Strip revitalizes wood while preparing it for any type of re-coating. Be assured that Injectable Safe-Strip will not harm pets, vegetation, shrubs, and flowers.
INJECTABLE SAFE-STRIP PRODUCT DESCRIPTION:
- New application technology allowing pressure washer injection
- Removes oil-based and water-based semi-transparent stains and sealers
- Restores weathered wood to natural color
- 100% biodegradable - will not harm plants or pets
- Does not contain chlorine bleach that may damage wood fibers
- Use on all exterior wood surfaces including decks, fences, and fascia
Surface Preparation:
Injecting:
1. Put injector hose into undiluted Injectable Safe-Strip container. Inject desired working area (200-300 sq. ft. recommended). Injector ratio 12:1 or lower.
2. Although Injectable Safe-Strip has little or no dwell time, 5 minutes of product working time is recommended. Pressure wash, working area thoroughly.
Ready-to-use:
1. Pour Injectable Safe-Strip into container. Add 4 parts water (1 gallon makes 5 gallons, 5 gallons makes 25 gallons). Apply liberally to wood surfaces. Best application results are with a Deck Sprayer. After application, always keep working area moist during surface preparation.
2. Once applied you may begin to scrub (NO SCRUBBING NECESSARY WITH USE OF PRESSURE WASHER). When scrubbing applied area, use synthetic, stiff bristle brush; do not use a wire or natural bristle brush.
3. Rinse thoroughly with hose or pressure washer. A pressure washer will show the best results.
* Use caution when using Safe Strip. Wet surfaces will be slippery.
Coverage Rate: Approximately 500-1000 square feet per gallon.
Reviews
There are yet no reviews for this product.
Please log in to write a review. Log in
You are guest ( Sign Up ? )
or post as a guest
-
We will reply to your comment shortly· 12/30/2020We are in the process of purchasing a log cabin in the northern lower peninsula of Michigan. The previous owners fell behind on maintaining the exterior, and there is a significant fungus build up on it (please see pictures). We've had the home inspected, and there does not appear to have any rot. I am considering using the TWP 100 series stain when we eventually get to that point, and I would like to stick with the same manufacturer through the process. Is the Safe Strip product capable of removing the fungus and previous stain? Can it be done at one time, or in two steps (fungus first, then previous stain second)? I do not know if the existing stain is water or oil based.
-
We will reply to your comment shortly
-
We will reply to your comment shortlyWe have converted a deck area to a 3 season deck. I did not have the opportunity to remove the stain on the deck prior to the new work being done. To enclose the deck area screen material was placed under the deck joists. Is there a deck stain stripper available that will not damage or corrode screen material?
-
We will reply to your comment shortlyNot sure if a stripper will harm it or not. Sorry.
-
-
We will reply to your comment shortlyWill this take paint off of side of house or trim of house? I have a deck 14' in air and surrounded by a painted band and 4 painted columns
-
We will reply to your comment shortlyNo, it does not remove paint.
-
We will reply to your comment shortlyGreat!! Will I need the same amount of TWP stain I used when the deck was new and never stained? It is pressure treated wood
-
We will reply to your comment shortlyYes, that is correct.
-
-
-
-
We will reply to your comment shortlyhave used sikkens srd for 20 + yrs but need to remove a few stubborn built up spots. recommend rad stripper/booster or safe strip?
-
We will reply to your comment shortlyDo you have pictures?
-
We will reply to your comment shortlyno, but spots are only against the house maybe 3 inches in size, definitely less than 5% of entire deck.
-
We will reply to your comment shortlyNeed pics to determine if a stripper will work or not.
-
-
-
-
We will reply to your comment shortlyHi - I need to restain our pergola (the same color) . . . it's been 10+ years. TWP was the original product used - no sure of series or color. Please provide direction on preparation and product. I like the way the original looks, just needs to be refreshed. I think it is cedar.
-
We will reply to your comment shortlyLooks like Rustic color. Prep first with this kit and pressure washing: https://www.twpstain.com/gemini-s-restore-a-deck-cleaner-and-brightener-kit
-
We will reply to your comment shortlyexcellent - thank you. 2 follow up questions:
1. On the cleaner, do you recommend spraying on and then powerwashing off? or adding the cleaner to the power washer?
2. On the product - do you recommend TWP 1500 or 100 series?-
We will reply to your comment shortly1. Apply and then pressure wash off. Cannot be applied with a pressure washer.
2. TWP 1500.
-
-
-
-
We will reply to your comment shortlyI need to re-stain my log home that I bought a few years ago but don't have the details on what was put on the logs. I've attached some pictures.
Can you help me:
1. Strip off what is there currently
2. Recommend a product to stain the logs with-
We will reply to your comment shortlyUnfortunately what you have on there looks to be a semi-solid to solid stain and that means it cannot be fully stripped. You might need to media blast to remove. Once done, use the TWP 1500 Series.
-
-
We will reply to your comment shortly
-
We will reply to your comment shortly
-
We will reply to your comment shortlyMore pictures
-
We will reply to your comment shortlyI stained my deck last night with two 100 dark oak. It rained about 7 hours after and now I have a lot of dark running spots down the vertical sides of my steps as well as a few lighter areas that seemed like they didn’t take up any stain. Should I clean with a power washer and re apply after letting the stain dry? Should I clean, sand, and re apply. Or should I use a stripper and start over. Deck is pine and approximately 12 months old
-
We will reply to your comment shortlyPost a picture of the stain after it fully dries from the rain water.
-
We will reply to your comment shortlyPics
-
We will reply to your comment shortlyAs you can see. I have a multitude of issues. Hardly any stain in some areas. Running stain in others.(some of this may have been poor application) And water spots from the rain!!! Please help me proceed:(
-
We will reply to your comment shortlyYou should remove all stain and start over. Your best option for this is the RAD Stripper: https://www.twpstain.com/restore-a-deck-stripper-brightener-kit-detail
-
We will reply to your comment shortly
-
-
-
-
-
We will reply to your comment shortlyI have TWP 120 on cedar siding. Mildew appearing so need to apply new water based stain because oil based no longer available in Maryland. Tried a cleaner with recommended sodium metasulfate to strip but that didn’t work well. Will this product strip the TWP 120 and how best to apply?
-
We will reply to your comment shortlyOil-based is allowed in MD as long as VOC compliant. The TWP 1520 Pecan is oil-based and allowed there.
Use this to strip the TWP 120. https://www.twpstain.com/restore-a-deck-stripper-brightener-kit-detail
-
-
We will reply to your comment shortlyI cannot even find the container (mom's caregivers moved everything) but I am pretty sure just 3 years ago I used cedar colored Thompson's stain on my new cedar grape arbor. It is starting to fade, and is really odd color now. Um, I am not going to be able to sand this, it has grapes growing over it. Any suggestions?
-
We will reply to your comment shortlyIt has to come off if you want to use TWP and that would entail sanding for this product. It will not strip off.
-
-
We will reply to your comment shortlyI tried the safe strip and it wasn't cutting it so I ended up getting the restore a deck cleaner & brightener kit. That worked well.
-
We will reply to your comment shortlyWe coated our new, covered cedar deck with TWP cedartone four years ago. It still looks good (not greyed) but it's getting very light in color and you can tell it needs to be done. I picked up some safe strip to clean it off before recoating, but I'm wondering whether I should use the other stripper and brightener instead of the safe strip. I do have a pressure washer. I haven't opened the safe strip and can easily return it if that's the better way to go. Thanks.
-
We will reply to your comment shortlyThe Safe Strip will work for you.
-
-
We will reply to your comment shortlyI have metal railings due I need to cover or tape them.
-
We will reply to your comment shortlyHard to say as the spindles are not all made the same. Usually, there are no issues but always test first and if an issue, you would need to cover.
-
-
We will reply to your comment shortlyIs this product safe for use on cedar siding? If not, is there a different TWP product which is? I'm looking to remove the existing stain and possibly apply a lighter color
-
We will reply to your comment shortlyWhat brand and type of stain are you trying to remove? Pictures will help.
-
We will reply to your comment shortlyFor years my house was stained with Sikkens Cetol SRD semi-transparent and a couple of years a go my contractor switched to Sherwin Williams Woodscape. I think the Sherwin Williams is an acrylic and it hasn’t adhered well over the oil-based Sikkens so I’m hoping I will have success in removing it so that I can switch permanently to TWP, which I’ve since been told is a superior stain
-
We will reply to your comment shortlyYou will not be able to strip multiple layer buildup up of an acrylic stain over Sikkens on vertical walls. It will have to be sanded off or corn cob blasted to be removed.
-
-
-
-
We will reply to your comment shortlySorry, one more. Is this product safe and effective for removing an acrylic stain such as Sherwin Williams Woodscapes?
-
We will reply to your comment shortlyIt will not remove an acrylic stain from wood siding.
-
We will reply to your comment shortlyThank you. The product description indicates it removes both oil-based and water-based stains. Aren’t water-based and acrylic stains one in the same?
-
We will reply to your comment shortlyThis will not work to remove a water-based acrylic effectively. You will need these products and booster/gel additives:
https://www.twpstain.com/restore-a-deck-stripper-brightener-kit-detail
https://www.twpstain.com/wood-stain-strippers/rad-stripper-additives
-
-
-
-
We will reply to your comment shortly
-
We will reply to your comment shortly